1
/
su
2
Esclusiva Fascia parasole Ufficiale - AK47 - AbarthExtreme mod.2
Esclusiva Fascia parasole Ufficiale - AK47 - AbarthExtreme mod.2
Prezzo di listino
€49,00
Prezzo di listino
Prezzo scontato
€49,00
Prezzo unitario
/
per
Imposte incluse.
Spese di spedizione calcolate al check-out.
Impossibile caricare la disponibilità di ritiro
Official Sun Visor Strip - AK47 - AbarthExtreme
Customizable sun visor strips in any color and model, CONSULT OUR LIST and then eventually write to us for other colors from the Palette.
The base, in addition to the default MATTE BLACK, can also be requested on a GLOSSY BLACK base.
THEY ARE NOT PRINTED AND THEREFORE DO NOT FADE IN THE SUN
Created from high-quality vinyl (5/7 years durability) to be installed on your car's windshield.
THEY ARE RESISTANT TO HAND WASHING, PRESSURE WASHERS, AND ROLLER WASHES.
INSTALLATION INSTRUCTIONS:
THEY ARE RESISTANT TO HAND WASHING, PRESSURE WASHERS, AND ROLLER WASHES.
INSTALLATION INSTRUCTIONS:
- Clean the affected area thoroughly with rubbing alcohol;
- Let it dry for a couple of seconds;
- Prepare a mixture of water and soap and pour it into a spray bottle
- Spray the water and soap on both the previously cleaned windshield and the adhesive side of the strip.
- Position the strip on the windshield (the water and soap will allow you to adjust the strip without it sticking immediately)
- With a squeegee, push out the water between the adhesive and the windshield from the center outwards
- Use a hairdryer to speed up the drying process and remove any small wrinkles that form
- After the strip is firmly attached to the windshield, trim the excess film at the edges with a sharp utility knife, using the edge of the glass as a guide
- Go over the entire graphic again with a hot air dryer to completely fix the adhesive to the windshield
- ENJOY YOUR NEW LOOK
N.B: expose the car to the sun for at least 24/48 hours without washing it or using brushes, in order to allow the water and soap mixture used for application to dry more thoroughly.
- Let it dry for a couple of seconds;
- Prepare a mixture of water and soap and pour it into a spray bottle
- Spray the water and soap on both the previously cleaned windshield and the adhesive side of the strip.
- Position the strip on the windshield (the water and soap will allow you to adjust the strip without it sticking immediately)
- With a squeegee, push out the water between the adhesive and the windshield from the center outwards
- Use a hairdryer to speed up the drying process and remove any small wrinkles that form
- After the strip is firmly attached to the windshield, trim the excess film at the edges with a sharp utility knife, using the edge of the glass as a guide
- Go over the entire graphic again with a hot air dryer to completely fix the adhesive to the windshield
- ENJOY YOUR NEW LOOK
N.B: expose the car to the sun for at least 24/48 hours without washing it or using brushes, in order to allow the water and soap mixture used for application to dry more thoroughly.
Share
